SD-002 Solenoid Points Slave Module

The SD-002 solenoid points slave module is used to operate points that are fitted with solenoid actuators. It connects directly to the central control unit (SD-001).

When the central control unit receives a command it decodes it and sends a data signal to the SD-002 slave unit which then pulses the solenoid to change the points.

Up to four of these slave units can be connected to a central control unit.

The solenoid actuated points slave module can switch two sets of solenoid actuated points in response to the data sent from the central control unit. One central control unit and four solenoid points slave module can control a total of eight sets of points.

The SD-002 solenoid actuated points slave module supplies a precisly timed pulse to give positive and reliable actuation of the points. This protects the solenoids from burn out. Separate capacitor discharge units are not required.

The solenoid actuated points slave module requires a separate power supply of 12 - 14 V DC.

The solenoid actuated points slave module uses two accessory decoder addresses, one for each set of points.

Module Operation

When a command to change a set of points is sent from the comamnd station, the central control unit receives the command via the track bus. When a command is received the central control unit decodes the command data packet to determine the accessory address and if a match is found the central control unit sends a signal to the slave unit. The solenoid points slave unit then sends a signal to the solenoid and the points change position.

If an address match is not found the command is ignored and no signal is sent to the slave units and the points do not change.

Control Options

Module Specifications

Top   Home Page   Back

If you are using Internet Explorer and do not have javascript enabled the Back button may not work. You can either enable javascript or use the browser Back button to return to the previous page.